The new MezzNet DX can be raised and
lowered by one ground level worker. Unlike other systems, it protects
employees without the need for tie off. It protects workers and products
at any elevated work or storage area. Custom made to any sized opening or
area. Brought to you by Baynets, the fall prevention specialists.
Fully Automated
Motorized
Remote controlled
Doesn't slow down operations
Doesn't take any floor space
Simple to install
Easy to operate.
Motorized MezzNet DX Specification Sheet
Support posts
and top rail are powder coated safety yellow
Safety net and border rope are
also safety yellow
Cycle time is around 8 seconds
in either direction
Top rail height is a minimum
of 60 inches above deck level
Yellow flashing strobe light -
active when system in motion
Piezo audio alarm - active
when unit is in motion
Programmable 4 second delay so
that light and alarm are activated prior to unit opening
Light and alarm are active
when unit is open
System is remote control
activated up to 250 feet
Thumb wheel remote control -
one control to operate up to 16 systems
Screwdrive mechanism assures
units does not back slide
Motors are mounted on top of
posts and are free of operating area
System can accommodate an
opening up to 18 feet in width
3 inch kick plate above deck
level
Bumper system protects netting
when system is open
System strength greatly
exceeds OSHA and other standards for guardrails and fencing, etc.
Base plate will accommodate
side by side systems so as to allow for multiple units to be installed
next to one another
Electrical receptacle designed
for easy hook up to customer supplied power - operates on a standard
current (115 Volts)